Turn this same wrench until the second hole can be seen, and then put the pin in that hole. Check how fast the door closes. Keep doing this until the door shuts and locks without slamming. You can modify this same commercial door spring hinge pressure with a hex wrench but pliers if your garage door doesn’t close hard enough to latch and the door slams shut. A hex wrench can be used to change hinges with screws on top. If there’s a slot with holes and now a small pin on the side of both hinges, you will need a tension rod to tighten and loosen the hinges.

How Many Door Springs Hinges Does Each Door Have?

Before we display how or when to adjust your self-closing hinges, users should know the number of times each door should have door springs hinges. We always say that each door should have two self-closing spring hinges. If you have two, put one at the top while the other is at the bottom. The middle joint can be a conventional butt hinge or a ball-bearing hinge. We suggest using as many as four taller Commercial Spring Hinges on Commercial Doors.

Best Tips For Adjust Self-Closing Hinges

● Top Hinge Screws Unscrew

If your hinge has such a screw on top to protect the spring, you will need to unscrew it. We’re using a screwdriver to take this screw apart and make it lose. Make sure you put the screw somewhere safe that you can find again. If your personality hinge doesn’t have a screw to lock it, you can leave this step out.

● Put the Hex Wrench over the Hinge.

Your hinge will come with a hole on top, whether it comes with something like a clamping screw or not. Put a hex screwdriver in that hole and push it in. If the wrench is rough, you can proceed with it until it fits further into a hex-shaped hole but locks into place. Make sure that the long final part of the hex wrench is 45 degrees from the door so that you can make the adjustments.

● Place the Tension Pin in the Hole.

Once the hinge is in the right place, you must put this same tension pin in the hole. Your Spring Hinges came with a very small pin.

● Change the other Hinge.

Modify this same bottom (as well as top) hinge so that it has the same tension as the other hinge. This will make both hinges even. You’ll make damn sure that the tension on both hinges is the same and that none of your classmates are too tight or loose.

● Examine the Door

When you have modified the hinges, test them while also opening the door and observing whether it closes properly. Watch how quickly or slowly the door shuts. If everything is just right, you are done modifying. If it’s slamming but rather latching shut, you’ll need to adjust or loosen these same hinges again.


Most states now have laws that say these must be on those doors. Self-closing hinges have tension that can be changed. If you recognize what you’re doing, it’s easy to change the tension. But if your door doesn’t close rather than latch properly, it could be because the spring tension on the self-closing hinge has become too loose or too tight. Users will need to utilize a few simple tools to soften or tighten it. A hex wrench can be used to change hinges with screws on top.


Please enter your comment!
Please enter your name here